Hello all- I was wondering if anyone can point me in the right direction. I am using the Public Beta 2 version of SoundDiver 3.1.0 on a Power PC G5 with LOGIC 7.2 loaded. I have been able to successfully use SoundDiver with a Waldorf Microwave XT (SD crashes sometimes) and a DOEPFER POCKET DIAL (no problem) but have had trouble in getting anywhere with SD with a few other units. Specifically I am having trouble using SD with a Korg T3, Sequential Circuits Prophet 600 and a DOEPFER DREHBANK. When I try to install the synths (T3 & P-600) SD scans the computer and then displays a message saying "No new devices found.....". I select the button on the bottom of that prompt that says MANUALLY and then the synth shows up on the list of devices. I then double click on the devices and set the MIDI INPUT and OUTPUT ports to the correct port and click on BUILD LIBRARY-->ALL ENTRIES to retrieve the patch library and then I get another error message saying :"SYSEX COMMUNICTIOAN ERROR SYNTH DID NOT RESPOND ...". I am sure that the MIDI connections are OK because I am communicating ok with them when not using SoundDiver. ANY TIPS, SUGGESTIONS, WELCOME AND APPRECIATED. When I try to install the DOEPFER DREHBANK I get a different message that reads:" ! MODEL DREHBANK CANNOT BE SCANNED EITHER BECAUSE THIS IS TECHNICALLY IMPOSSIBLE OR BECAUSE THE ADAPTATION DOES NOT YET SUPPORT SCANNING.." I click on the button ADD to add manually and the DREHBANK then shows up on the device list. I double click the DREHBANK icon from the device list and then try to BUILD LIBRARY --> ALL ENTRIES and SD does it's thing and says that it is retrieving data from the DREHBANK but after it finishes the list is still blank and when I select an individual empty slot on that list I get a new window from SD that says "THIS ENTRY IS UNKNOWN. REQUEST IT?" . So I click on the button that says OK but nothing happens, no new windows open up. If when I get that last prompt I click on the button that says INITIALIZE I get a window titled:"DREHBANK: Slot E "Slot********". At the top of the window it says "Drehbank: EasySlot = Bytekette von 95 Bytes mit einer Variabien" Also a button that says : "STORE TO EPROM". There are about ten more pulldown settings plus a table list of 48 pull down tabs for MIDISTRING. Needless to mention that I am a bit lost in what I should try next. I would really like to be able to edit patches for the PROPHET and the T3 also to back up the patch library but I really NEED to figure out how to make the DREHBANK play nice with SD because as I am using a MAC there are no other editors for it. Does anybody out there use the SD with the DREHBANK? Any help or tips or suggestions welcome and appreciated. thanks,alex