On Mon, 19 Mar 2007 20:23:08 -0500 "Brian Frank" <forums@logic-users.org> wrote: > Hi, I was hoping you guys could point me in the right direction on this one. > When I install the Matrix-1000 adaptation into SoundDiver3 (PC version) it > has the ROM section populated with the default patch names which are very > descriptive and I find them to be quite helpful while browsing sounds. The > problem is, every time I wish to edit one of these patches for the first > time, SoundDiver requests the patch settings from the Matrix and the patch > name is automatically overwritten with something like "BNK3: 57" depending > on the bank and patch#. This generic patch name is not only copied to the > temporary edit buffer, but it overwrites the default patch name in the ROM > section as well. Also, manual attempts to change the name back are > unsuccessful due to the fact it's in the ROM section. Is there any way I can > configure SoundDiver to retain the default patch names in the ROM section of > the Matrix-1000 adaptation? Thanks for your help! :-) actually, I'm not familiar with SoundDiver, but this behaviour is due to a flaw in the Matrix 1000 firmware. When requesting a patch, it really tells those silly patch names. Rumour hast it that there was not enough ROM space to include the names, so they are synthesized. Apparently, SoundDiver assumes that a name reported from the specific device won't be any worse than what it already has in the bank list. Well, in this case it IS worse. Sorry, don't know if it can be corrected within SoundDiver. Christian