>I'm using Logic Express 7.2 on an intel IMac. I opened an old midi project >from my PC 4.8 days and it seemed to work fine. I then decided to replace >the old midi drums with apple loops primarily from Drums on Demand's "Tight >and Dry" collection. This worked fine until I had a jump of four bars >where there were no drum sounds. When I added the loops after this they >were slightly delayed. I ran them along side the original midi drums to >confirm this. How do I correct this problem since the loops seem to be >snapped to the bar grid and should work properly? Thanks, >Greg McKitrick Not sure I'm the right guy to answer this, but I noticed a similar problem when I tried to put the same loop in repeatedly...after a couple of bars the sync was lost. What I did was to expand (by pulling the right side of the loop) the loop across all the measures I needed it for. Obviously, this will work better for drum loops than, say, a bass loop. EB