From: "Leszek Gasiorek" <leszek@...> >Still can't figure out how to bounce all audio tracks to >one stereo track using DSP Factory. The Bounce button >is not visible anywhere. Can anyone help? Hi, you don't say if you have the AX44, but I will assume you do. With the AX44 it is really simple. This is how I do it. I route all the audio tracks in Logic to outputs 5 & 6 including the midi audio feed which comes in on 17 & 18. I then route two patch leads from the AX44 outputs 3 & 4 ( which is 5 & 6 in Logic, as the DSP 2416 outputs are 1 & 2 ) into inputs 1 & 2 on the AX44 ( 3 & 4 in Logic as the DSP 2416 inputs are 1 & 2 ), and set the two channels in Logic 13 & 14 to record. When you play the song now you should get an input on your 13 & 14 tracks, which if you have set as a stereo pair should give you your master track. If you are not truly mastering, but just bouncing then you can just route whatever tracks in Logic to outputs 5 & 6 that you want to mix. A good little tip is you can sometimes route a midi's audio mix in this way and create a wav file and then manipulate it for effects. For instance I recently did this for a bass guitar part (general midi) and then routed it back through the 'Pod' and got some good natural bass guitar sounds which I then fed through Sound Forge to clean up any noise and change frequencies slightly. It was a bit long winded and took a while but the end result was well worth it. Hope this helps. Regards, Phil