>What I need to know is can I :- >Use the converters of both Adats as an interface to Logic (simultaneously) >Syn the Adats and Logic together (which I couldn't with the PCR) >Achieve sample accurate transfers between Adats and Logic. Nick, AFAIK, Logic has never had the ability to sync to ADAT 9 pin- if that's what you are asking about. Even if your audio interface has the connectors to do so, logic (as yet) can't access them to do sample accurate 9 pin sync. This has been lamented numerous times on this list. It works flawlessly in Audio Desk (Mac only software bundled with MOTU 2408), but no joy in Logic. I would love to be proven wrong however :) Didn't Emagic OEM the software bundled w/ the PCR that does sync to ADAT 9 pin? Strange if so... I can use the ADAT converters w/ my 2408 with no problems. Everyone raves about the hammerfall :) Good luck, Russ

--- In logic-users@y..., Russ Haynes <russhaynes@a...> wrote: > >What I need to know is can I :- > >Use the converters of both Adats as an interface to Logic > (simultaneously) > >Syn the Adats and Logic together (which I couldn't with the PCR) > >Achieve sample accurate transfers between Adats and Logic. The Hammerfall DSP Multiface and Digiface have an ADAT 9pin sync in connector. However, this is for sourcing wordclock only from the 9pin and not for timecode. The Hammerfall drivers do not contain an MTC driver that would pass timecode on to Logic. This was actually an ugly surprise for me. I still have to use my Sonorus StudI/O with SyncI/O card for doing ADAT transfers into Logic. You're right, the PCR card is worthless. Good Luck, Randall