>Eric Moon wrote: >Is there any way to monitor the inputs to the 1212 card without >putting an audio track into record?? ... >Any ideas?? ... idea 1: Wait for LAM 4.5 and then use its newly introduced (Realtime-)Audio-Input-Objects. ;-) idea 2: Have the 1212 I/O Utility application open beside Logic: --- Route the Input where your Sampler is connected and the ADAT-Input that you are using to the Output that you want to monitor. --- Set the Volume of those to the desired Monitoring-Level. --- Set all other Volumes to -96 dB. In LAM´s Mixer set the Monitoring-Volume for the desired Channels to Zero (the Mixer-Objects can remember different Volumes for being rec-enabled or not). >I'm also bringing inputs in digitally from my ADAT, ... >Also, any easier way to get at the clock source? ... easier way 1: Assign a key-command to "Audio Hardware Setup". easier way 2: Loopback-Cable your Device (that is connected to the ADAT-Input of the Korg-Card) to the S/PDIF or ADAT-Output of your Korg-Card ---> Then always use Logic as Master-Device (Internal Sync).