On 10/1/06 4:43 PM, "Roman Pirie" <romanp@xtra.co.nz> wrote: > > > > > I have an audio instrument that I have automated the mute through out a > song. I wanted to change the muting so I edited the muting visually on > the track suing the pointer. > Upon playback the old muting timing was used even though visually I was > watching the automation muting line showing a different timing of the > muting. > So I tried writing over the tracks automation by setting the audio > instruments channel to 'write' automation mode. Even in write mode it > switched back as if the old muting data was still there. > > > > Roman: I¹m not sure what is happening, but did you try using the ³erase automation² command? That usually works when there is some gremlin hiding on the track...you can erase all automation or currently visible automation. Maybe you know this and prefer not to do it....Logic should respond to what you say you are doing, but sometimes things do get messed up in ways that are not at all obvious. Blair -- blairfisher@shaw.ca