Am 30.07.2004 um 09:30 schrieb logic-users@yahoogroups.com: > So, are there any tricks involved with using more than one MIDI > interface? > I'm sure lots of people do it, but the Tascam US-428 sure doesn't seem > to > like it....I would like to get the AMT-8 back in the system if I can. Normally this should work. The MIDI port assignment should stay intact. I say "should", because doing so is some work, as when you add a MIDI interface, MIDI port enumeration changes. So it's a good idea to check if the MIDi in and out ports of the US-428 still are "US-428 Control Port". > BTW - after reading the Logic manual I tried to check out the MIDI > device > plugins - the US-428 plugin was listed as being controlled by "Unitor 8 > control" (which I don't even use) so it appears that the Emagic > interfaces > try to control other MIDI devices attached to the system?? This is just a side effect that control surface plug-ins use the same file format as SoundDiver Modules, and Unitor8 Control is a stripped-down SoundDiver. Therefore the Finder thinks that the US-428 plug-in can be used by Unitor8 Control. Beste Gruesse - best regards, Michael Haydn - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Dipl.-Inform. Univ. Michael Haydn mhaydn@... Logic Developer http://www.emagic.de/ SoundDiver Group Executive Emagic Soft- & Hardware GmbH - Germany Phone: +49 4101 495 0 Halstenbeker Weg 96, 25462 Rellingen Fax : +49 4101 495 199 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -