Am 29.07.2004 um 02:09 schrieb logic-users@yahoogroups.com: > I'm newbie having a major problem with LC: Updated to Logic Pro 6.4.2 > on > a DP 800/10.3.4 and can't get the LC running... Error 1 showing up in > LC > display. Can't see any data displaying when booting again. Is the > firmware corrupted? Tryed to update from older LP versions, no > success... > Any help out there? When the display is blank at power-up, the firmware is gone. In that case click "Write Firmware" in Logic's Control Surface Setup window. It will instruct you to power up the Logic Control with some buttons held down. If you still get errors, please switch off all other MIDI equipment. It might disturb the upload process, as the bootloader is very picky. If this still doesn't work, please contact Emagic support, where you can get a Standard MIDi file which you can send directly. Beste Gruesse - best regards, Michael Haydn - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Dipl.-Inform. Univ. Michael Haydn mhaydn@... Logic Developer http://www.emagic.de/ SoundDiver Group Executive Emagic Soft- & Hardware GmbH - Germany Phone: +49 4101 495 0 Halstenbeker Weg 96, 25462 Rellingen Fax : +49 4101 495 199 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -