show first message show previous message Showing Logic-TDM Message 25397 of 25802 show next message show last message

Forum Index | Read L-TDM: Policy/Rules Messages Threads Digests | Post New Message | Search!

From: Lee Blaske <lblaske@pclink.com>
Date: Wed, 7 Nov 2007 at 1:42:59 PM
Subject: Re: [L-TDM] Re: recording to audio channels 65 or higher.... no go
Message #25397
This is a reply to #25351.
Just saw your post, after I posted my problem. I'm having a similar problem, but my difficulties start with channels 33 and higher. Lee Blaske On Oct 1, 2007, at 10:24 AM, David G Burns wrote: > Thanks Mark-looked around and could only find project settings/ > recording/DAE recording > folder,where you can enter a location and "set".Under 7 there was > the option of "song > folder" versus "global",which seems to be gone now.I think it's a > deeper problem than that > because I get the tdm setup icon after hitting record on any track > above 64 and than the > bounce ball,and than Logic crashes and creates a crashed song > doc.I'm fearing that PT 7.4 > will be the cure,unless anyone else can confirm or deny my > glitch.Is anyone out there > running LP8 under TDM with 7.3.1 and can record on track 65 or > higher.I can't be the only > one here.... > holding my breath > David > > --- In logic-tdm@yahoogroups.com, "ativity2003" <me@...> wrote: > > > > If L8 allows it, did you REMOVE RECORD PATH before trying to record > > above track 64? This is in Audio Config in L7, so don't know > where it > > can be found in L8...anyway, for me, doing that in L7 always > corrected > > the problem you describe. > > > > best > > > > Mark > > > > > > > > > > --- In logic-tdm@yahoogroups.com, "David G Burns" <david@> wrote: > > > > > > Been with LP8 for a week or so,can't seem to be able to record to > > audio tracks 65 or higher > > > under tdm,simply crashes.Tried with virgin LP8 template as well as > > older LP7 ones.PT works > > > fine.dual G5 1.8,OSX 10.4.10,PT 7.3.1 cs4,TDM HD3 accel. > > > > > > Other misc annoyances-1-turning touch auto creates a duplicate > > track below in the arrange.. > > > 2-the mackie control defaults to viewing 16 rather than 8 > tracks,as > > though it thinks there are > > > two controllers,and shows the second one's tracks so there is an > > offset between what the > > > arrange shows as being on the control surface,and what is actually > > displayed on it.Being in > > > "single mode" works as expected though...any one else has this..?? > > > > > > > >
Viewed 567 times, 2 replies, 8 messages in thread. Reply to this message. Read this thread.

Forum Index | Read L-TDM: Policy/Rules Messages Threads Digests | Post New Message | Search!


© 1994-2008, All Rights Reserved.