show first message show previous message Showing Logic-TDM Message 25351 of 25802 show next message show last message

Forum Index | Read L-TDM: Policy/Rules Messages Threads Digests | Post New Message | Search!

From: "David G Burns" <david@bartmart.com>
Date: Mon, 1 Oct 2007 at 10:24:39 AM
Subject: [L-TDM] Re: recording to audio channels 65 or higher.... no go
Message #25351
This is a reply to #25350.
Thanks Mark-looked around and could only find project settings/recording/DAE recording folder,where you can enter a location and "set".Under 7 there was the option of "song folder" versus "global",which seems to be gone now.I think it's a deeper problem than that because I get the tdm setup icon after hitting record on any track above 64 and than the bounce ball,and than Logic crashes and creates a crashed song doc.I'm fearing that PT 7.4 will be the cure,unless anyone else can confirm or deny my glitch.Is anyone out there running LP8 under TDM with 7.3.1 and can record on track 65 or higher.I can't be the only one here.... holding my breath David --- In logic-tdm@yahoogroups.com, "ativity2003" <me@...> wrote: > > If L8 allows it, did you REMOVE RECORD PATH before trying to record > above track 64? This is in Audio Config in L7, so don't know where it > can be found in L8...anyway, for me, doing that in L7 always corrected > the problem you describe. > > best > > Mark > > > > > --- In logic-tdm@yahoogroups.com, "David G Burns" <david@> wrote: > > > > Been with LP8 for a week or so,can't seem to be able to record to > audio tracks 65 or higher > > under tdm,simply crashes.Tried with virgin LP8 template as well as > older LP7 ones.PT works > > fine.dual G5 1.8,OSX 10.4.10,PT 7.3.1 cs4,TDM HD3 accel. > > > > Other misc annoyances-1-turning touch auto creates a duplicate > track below in the arrange.. > > 2-the mackie control defaults to viewing 16 rather than 8 tracks,as > though it thinks there are > > two controllers,and shows the second one's tracks so there is an > offset between what the > > arrange shows as being on the control surface,and what is actually > displayed on it.Being in > > "single mode" works as expected though...any one else has this..?? > > >
Viewed 988 times, 1 reply, 8 messages in thread. Reply to this message. Read this thread.

Forum Index | Read L-TDM: Policy/Rules Messages Threads Digests | Post New Message | Search!


© 1994-2008, All Rights Reserved.